Installation and operation of dust centrifugal ventilator

- Dec 20, 2018 -

After the dust centrifugal ventilator is installed, it can be started only when its equipment is completely normal. To a certain extent, in order to ensure the normal running performance of the fan to meet its requirements, the accident can be prevented. Effectively extend the life of its equipment.

The direction of rotation of the fan of the dust centrifugal ventilator should be consistent with the direction of rotation indicated on the nameplate of the fan. Install a regulating valve on the air inlet pipe of the fan. Before driving, you need to turn it off. Wait for the fan to run, then slowly open it to the specified working condition and detect the motor current.

The dust centrifugal ventilator checks the operation of the fan at any time. If abnormal phenomena are found, the cause should be identified in time and the machine should be shut down for maintenance. Regularly remove dust, dirt and other impurities inside the fan and pipe according to the specific conditions used, and prevent corrosion.

The dust centrifugal ventilator can observe the temperature rise and lubrication of the bearing at any time to keep the oil window clean and bright, and the lubricating oil used by the fan should be replaced regularly, especially after each repair. Establish necessary management systems, develop safe operating procedures, and develop equipment maintenance rules. The daily maintenance of the ventilator should be handled by a special person and the daily maintenance record should be made.