I. Structure of the Air shower chamber:
The air shower room consists of a large box (blower, filter installed in this box), small box (double hair shower room This side to install the nozzle, the quantity and the big box are consistent, the roof (installs the embedded type illumination lamp), the inner floor (stainless steel sand board), the air shower room double door body and other accessories: filters, the fan, the Intelligent circuit board, the nozzle, shines the lamp and so on composition.
Two, double blowing right angle wind shower room and the corner of the material-related:
A, the size of the wind room can be optional: cold-rolled steel multi-layer pickling electrostatic spraying or all stainless steel, all stainless steel has 201 stainless steel and 304 stainless steel.
B, 201 stainless steel with acid, alkali, high density, no bubble polishing, no pinhole and other characteristics, is the production of a variety of case, strap bottom cover high-quality materials.
C, 304 stainless steel is a versatile stainless steel material, anti-rust performance than 200 series of stainless steel material to be strong. High temperature resistance is also relatively good, can be up to 1000-1200 degrees. 304 stainless steel has excellent corrosion resistance and good intergranular corrosion resistance. For oxidizing acids, it is found in the experiment that the 304 stainless steel has a strong corrosion resistance in the nitric acid under the boiling temperature of the concentration ≤65%. The alkali solution and most organic acids and inorganic acids also have good corrosion resistance.
Third, the air shower room is one of the best purification equipment to enter the cleanroom buffer, which uses the high speed airflow to blow down and remove the particles attached to the surface of the personal clothing or material. Eliminate the staff will be hair, dust, bacteria into the workshop, to the workplace to achieve strict dust-free purification standards, the production of high-quality products.
Four, double blowing right angle wind shower room and the angle of the difference between the room:
A, the corner of the wind room is the customer on-site site requirements non-standard, is also in line with the workshop two out of the design, to meet the requirements of clean room, more reasonable to reduce the cost of enterprises.
B, straight into the wind shower room is a standard design method, from the door to enter, from the direction of going out.
C, the air shower room to purify all the use of the most advanced international CNC punching equipment, CNC punching machine can be more accurate positioning accuracy in ±0.01mm, can effectively improve the quality of the air shower room product.
V. the corner wind shower room and direct inlet direct out of the air shower function configuration:
1, the corner of the wind shower room and straight into the direct out of the air shower can be set up single blow, double blowing, three blowing method.
2, the door body can be designed to become automatic door or manual door device