Correct use of High Pressure Centrifugal Blower

- Jun 27, 2018 -

High Pressure Centrifugal Blowers are widely used in industrial production. As users, we should use the equipment properly to make full use of its performance. Then, what problems need to be paid attention to in practical applications? Next, we will analyze and discuss this issue. We hope to increase our understanding and understanding of High Pressure Centrifugal Blowers.

 

First of all, during the use of High Pressure Centrifugal Blower equipment, it is necessary to control its working pressure. Pressure relief valves are commonly used at work today, which is a commonly used unloading valve. When its use pressure exceeds the pressure set by the relief valve, the relief valve will automatically open, releasing the excess pressure and thus protecting it. The second is to do a dust job. Usually a fan is equipped with a high-precision filter.

 

It should be noted that for different working environments, filters that are suitable for precision are needed, and there are different methods for their maintenance. In addition, in some special occasions, special protection is also required: For example, when used in a sealed environment, pay attention to ventilation and heat dissipation; when the ambient temperature (intake air temperature is relatively high), pay more attention to ventilation and heat dissipation, or select allow High temperature centrifugal fan with high temperature.

 

At the same time, with the wide use of High Pressure Centrifugal Blowers, the selection of the High Pressure Centrifugal Blowers is becoming more and more complicated, and it is usually required to select according to the conditions of use at the work site. In other words, to determine its main function is to suck or blow, and to find out the corresponding pressure - flow curve of the fan; if you look at the wrong curve, sometimes the selected product can not be used. The

 

Next, according to the calculated parameters such as pressure and flow rate, find the working curve above the working point corresponding to the pressure and flow at the same time on the graph; then select the model of the High Pressure Centrifugal Blower according to the working curve; this is because of the work site. Different conditions require different pressures and flow rates. Therefore, in order to obtain relatively accurate data, relevant calculations are required.

http://www.wxltfan.com/